What factors affect the polishing effect of the polishing machine

Manual polishing machine polishing man-hour cost, the cost of accessories is high, what factors affect the polishing effect of the polishing machine? In order to improve production efficiency, polishing has become a very important production equipment. The polishing consumables used in the polishing machine have the following structural forms: 1. Stitched multi-purpose coarse cloth, linen cloth and fine plain cloth No matter the application field of the process method, the surface engineering made by stitching is inseparable and closely related to the nanomaterial technology. The above is a detailed introduction of consumables for polishing machines.

    The purpose of rough polishing is to remove the polished damage layer, with the maximum polishing rate, which can ensure that the product is very stable in quality during the production process, and avoid the problem of quality differentiation, so the use effect in all aspects is Ideally, when the polishing pad with too much dirt cannot be cleaned, replace it in time. 2. Polishing machine operation procedure 1. Before polishing, it is necessary to remove the ground garbage, debris and sand, etc. 2． Check whether the polishing brush of the polishing machine is clean and whether it is replaced, 3． Check whether the controller of the adjustment key is in the normal speed position. 4． Connect the power source, the operation should start from the place closest to the power source, turn on the machine and let the machine run at high speed, and then stick to the ground for polishing. The walking route is a straight line, and the back polishing position should overlap the front polished ground. 3. Notes for polishing machine 1. Do not drive the machine too fast to avoid collision. 2． Do not operate the machine in a flammable and explosive atmosphere 3． Do not raise the operating lever during operation, as this will cause the machine to lose control. 4． Do not press things on the machine, because it has a precise balance range. When the operating lever needs to be moved during operation, all wires must be moved first. The ground wire must be connected to the switch box motor. Wrong connection will result in electric shock. 4. After the polishing machine is maintained and used, remove the needle holder and polishing pad and clean the surface and parts of the machine with a clean cloth. When not in use, use a useless The pad is placed under the drive plate for protection. Check whether the air vent of the motor cover is unblocked. If the dust is thick, the motor housing must be removed, and all the dust must be removed with a vacuum cleaner. The wheel bearings must be frequently lubricated. Anti-rust, complete overhaul every time.